Cleaning formwork.

When to remove concrete formwork?

Cleaning formwork with the innovative Betoff fluids saves you time and money. However, before
cleaning the formwork, it must be removed. Molds should not be removed until the concrete has
hardened enough to be able to support any loads that can be exposed.
The support period (the period that has to elapse from the time when the concrete is poured into the mold and when it is removed from it). This period varies according to the type of cement used and the type of the formwork. As a rule, load-bearing structures should not be removed until 7 days, and wooden ones 28 days from the day of the concrete laying.

THINGS TO PAY SPECIAL ATTENTION TO WHEN REMOVING THE FORMWORK

Under no circumstances shall the mold be removed until the concrete has gained strength of at least
twice the strength that the concrete initially used to have during the application
The strength in question is the strength of the concrete using the same cement and aggregates, in the
same proportions, and hardened in temperature and humidity conditions similar to those in the area.
Where it is possible, the formwork should be left for a longer time to enable the concrete to harden better. Under normal circumstances (generally when the temperature exceeds 20°C) and when ordinary cement is used, the molds may be removed after different periods.

  • Walls, columns and vertical sides of beams 24 to 48 hours, as decided by the chief engineer.
  • Plates (supports left beneath) Three days
  • Soffits of beams (left supports) 7 days
  • Removal of board supports (span to 4.5 m) 7 days
  • Removal of board supports (over 4.5 m long) 14 days
  • Removal of supports for beams and arches (span up to 6 m) 14 days
  • Removal of supports for beams and arches (longer than 6 m) 21 days
  • For quick curing cement, 3/7 of the above period will be sufficient in all cases, except for the vertical sides of the boards, beams, and columns which must be left for 24 hours.

All formwork must be removed without hitting or causing vibration as this could damage the reinforced
concrete. Before removing the floor and spacers, the concrete surface should be exposed, if necessary, to
ensure that the concrete has cured sufficiently. Precautions should be taken to reduce the degree of
hardening that will happen to all components on cold days.

Cleaning formwork with BETOFF-BIO

CLEANING FORMWORK? HOW TO CLEAN CONCRETE FORMWORK?

Concrete formwork is very susceptible to cement dirt and should be cleaned with professional agents
created for this purpose. Most formwork cleaning fluids are those used when removing concrete from
concrete trucks or machines. They are mainly used in the construction of roads, residential buildings, and
other facilities. Until recently, there was not much choice on the market. All the concrete removal fluids
were very similar in composition and efficiency. However, as in every industry, innovative solutions have
appeared in the chemicals for the construction industry that have made work much easier. In the case of
concrete removal fluids, such an innovation, is undoubtedly the Betoff liquid and its biodegradable Betoff-Bio variant.

Cleaning formworks

CLEANING FORMWORK. ARE INNOVATIVE CLEANING LIQUIDS FOR FORMWORK BETTER THAN CONVENTIONAL ONES?

The innovation in the case of Betoff and Betoff-Bio liquids is the fact that they do not burn during
application, do not irritate the respiratory tract and are three times stronger than other liquids available on the market (Betoff). As for Betoff-Bio, it is a plant-based fluid that perfectly dissolves fresh concrete
stains. It dissolves oil, grease, lime, and cement dirt from any surface.

Leave a Reply

Your email address will not be published. Required fields are marked *